Herbicide leaching on a recharge area of the Guarany aquifer in Brazil

The region of Ribeir?o Preto City, located in Southeast of Brazil, S?o Paulo State, is an important sugarcane, soybean, and corn producing area with a high level of pesticides utilization. This region is also an important recharge area for groundwater supply of the Guarany aquifer. Since the past ten years atrazine, simazine, ametryn, tebuthiuron, diuron, 2,4-D, picloram, and hexazinone are the main herbicides used in this area. In order to study a possible leaching of some of these herbicides into the aquifer, surface, and groundwater samples were collected in a watershed during the years of 1996 to 2003, from different locations. To detect and quantify the herbicides a GC-MS (gas chromatograph/mass spectrometry) method was used. The response of the herbicides analyzed was linear over the concentration range of 0.02 to 2.0 microg/L. Analysis of groundwater revealed that the herbicides tebuthiuron, diuron, atrazine, simazine, and ametryn were not present in the samples. In the surface water collected in 1997, ametryn was present in two out of nine locations with concentrations ranging from 0.17 and 0.23 microg/L, which is above the allowable 0.1 microg/L according to the European safety level. The leaching potential of tebuthiuron, diuron, atrazine, simazine, 2,4-D, picloram, and hexazinone has been evaluated using CMLS-94, "Chemical Movement in Layered Soil," as simulation model. No leaching into the depth of the water table at 40 m was found.     

A study of the particulate matter PM10 composition in the atmosphere of Chillán, Chile

Inhalable particulate matter (PM10) concentrations were measured over 24-h intervals at six different urban sites in the city of Chillán from September 2001 to April 2003. Sampling locations were selected to represent central city, commercial, residential, and industrial portions of the city. Chemical composition of PM10 was performed to samples of 47 mm diameter Teflon membranes within the city of Chillán. The spatial and temporal variability of the chemical composition of PM10 was evaluated taking into account additional data from meteorology and further air pollutants. The majority of PM mass was comprised of carbon, nitrate, sulfate, ammonium, and crustal components but in different proportion on different days and at different sites. The chemical analyses showed that carbonaceous substances and crustal material were the most abundant component of PM10 during the winter and summer, respectively. The concentrations of PM10 were higher during the cold season than during the warm season. The PM10 concentrations were higher in the downtown area of the city of Chillán, where also the chemical composition was more variable due to urban traffic and other anthropogenic sources.     

Effect of backyard burning on dioxin deposition and air concentrations

The influence from open burning of garden and household waste on locally measured dioxin deposition and air concentrations was evaluated in three sets of experiments: the combustion of garden waste in barrels and in open fires, and the incineration of household waste in an empty oil drum. Each set was composed of eight individual experiments over 4 h. Deposition gauges were located 20 m NE, SE, SW and NW with respect to the source and on a background location at 400 m SW. Air samples were taken in the plume with a medium volume sampler equipped with a quartz filter and a polyurethane plug. The results illustrate deposition increments in the wind direction at a distance of 20 m from the source of 0.8 pg TEQ/m2 day for garden waste and 2.5 pg TEQ/m2 day for household waste. Concentrations in the plume were increased by 160-580 fg TEQ/m3 over a period of 12 and 31 h respectively. Expressed at a reference CO2 concentration of 9% this corresponds with a range from 0.8 to 3.6 ng TEQ/m3, which is comparable with a poorly controlled MSWI. Emission factors in the order of magnitude of 4.5 ng TEQ/kg combusted garden waste and 35 ng TEQ/kg burned municipal waste were determined.     

Substance flows through the economy and environment of a region

In the tradition of the study of materials flows through society, the Substance Flow Analysis (SFA) method and its software tool SFINX are presented. SFA aims at providing the relevant information for a country’s overall management strategy regarding single substances or coherent groups of substances. Three modelling techniques and their possibilities and limitations are discussed: Bookkeeping, static modelling, and dynamic modelling. The computer program SFINX can be used for varoius purposes: (1) to obtain an overview of stocks and flows of a substance in, out and through a nation’s economy and environment for a specific year, (2) to trace the origins of specific pollution problems, and (3) to estimate the effectiveness of certain abatement measures. Each application has its own requirements with regard to data and modelling.     

Substance flows through the economy and environment of a region

Part I: Abstract  In the tradition of the study of materials flows through society, the Substance Flow Analysis (SFA) method is presented. SFA aims at providing the relevant information for a country’s overall management strategy regarding single substances or coherent groups of substances. This article is dedicated to the presentation of a threestep general framework for SFA-type studies, and elaborates on its first step the systems definition. Attention is given to the definition of the external and internal system boundaries, the categorization of the system’s elements, aspects of materials choice, time, and space, and how these depend on the aim of the conducted study. Moreover, a broader discussion is started on the need for standardization of materials flow studies in general. Part II: Abstract  In the tradition of the study of materials flows through society, the Substance Flow Analysis (SFA) method and its software tool SFINX are presented. SFA aims at providing the relevant information for a country’s overall management strategy regarding single substances or coherent groups of substances. Three modelling techniques and their possibilities and limitations are discussed: Bookkeeping, static modelling, and dynamic modelling. The computer program SFINX can be used for varoius purposes: (1) to obtain an overview of stocks and flows of a substance in, out and through a nation’s economy and environment for a specific year, (2) to trace the origins of specific pollution problems, and (3) to estimate the effectiveness of certain abatement measures. Each application has its own requirements with regard to data and modelling.     

Fenton's pre-treatment of mature landfill leachate

The aim of this study was to check the effectiveness of the Fenton's reagent (Fe2+ + H2O2 + H+) for the pre-treatment of a municipal landfill leachate with the objective of improving its overall biodegradability, evaluated in terms of BOD5/COD ratio, up to a value compatible with biological treatment. The leachate came from a municipal sanitary landfill located in southern Italy and the average values of its main parameters were: pH=8.2; COD=10,540 mgl(-1); BOD5=2,300 mgl(-1); TOC=3,900 mgl(-1); NH4-N=5210 mgl(-1); conductivity=45,350 microScm(-1); alkalinity=21,470 mgl(-1) CaCO3. The effect of initial pH value on the pre-treatment effectiveness was evaluated by titrating the amount of acidic by-products formed. The extent of leachate oxidation was monitored and controlled by both pH and redox potential measurements. The best operational conditions for achieving the desired goal (i.e., BOD5/COD> or =0.5) resulted: Fe2+=275 mgl(-1); H2O2=3,300 mgl(-1); initial pH=3; reaction time=2 h. At the end of the Fenton's pre-treatment, in order to permit a subsequent biological treatment, residual ferric ions were removed increasing the pH up to 8.5 by adding 3 gl(-1) of Ca(OH)2 and 3 mgl(-1) of a cationic polyelectrolyte, the latter as an aid to coagulation. This final step also resulted in a further modest removal of residual COD due to co-precipitation phenomena.     

Degradation of para-hydroxybenzoic acid by means of mixed microbial cultures

Olive mill wastewater contains some phenolic compounds that cause antibacterial activity of a kind that prevents biological treatment without previous dilution. Among these phenolic compounds, p-hydroxybenzoic acid (PHB) is considered to be one of the most representative. This work examines the biodegradation of PHB by aerobic microbial mixed cultures previously acclimatized to glucose, which was used as an easily biodegradable model compound. Microbial growth runs were carried out in a batch reactor in the PHB concentration range of 200-1000 mg/L. In all the runs the PHB proved to be completely degradable. The specific growth rates obtained were in the range of 0.16-0.35 l/h. Experimental runs showed that the functional relationship between the specific growth rate and PHB concentration was that proposed by Monod. The kinetic constants of the Monod equation (mu(max) and K(S)) and biomass yield coefficient (Y) were determined experimentally. With the parameter values thus obtained, a mathematical model that also takes account of the duration of the lag phase was employed to describe both the microbial growth and the consumption of PHB. The concentration values of the model fit well with the data obtained experimentally.     

Spatial and seasonal variation in heavy metals in interstitial water of salt marsh soils

The composition of interstitial water collected from a salt marsh in NW Spain showed clear seasonal and spatial variations associated with redox cycles of Fe and S. In the summer, salinity increased in all soils as a consequence of the increase in evapotranspiration. The pH and concentrations of heavy metals also differed with season, but not all environments showed the same variations. Soils not colonized by plants had the highest pH and lowest heavy metal concentrations in the summer. These results support the idea that higher temperatures lead to an increase in the activity of sulfate-reducing bacteria, which in turn leads to an increase in alkalinity and concentration of sulfides in the water. Trace metals tend to precipitate with sulfides under these conditions and are removed from the interstitial water. In contrast, in the soils colonized by Spartina maritima, the oxidation of metal sulfides during the summer led to a decrease in pH and an increase in the metal concentrations in the interstitial water. The results obtained concur with those found for seasonal variations in metal sulfides in soils from the same salt marsh.     

Online hourly determination of 62 VOCs in ambient air: system evaluation and comparison with another two analytical techniques

This paper presents results of the processing and validation of data collected by an automatic gas chromatograph (AGC). This system was used to monitor 62 volatile organic compounds (VOCs) in urban air in the Basque Country, Spain. The nonpolar compounds (C2-C10) identified-paraffins, olefins, aromatics, and chlorinated compounds-accounted for 88% of the mass of total non-methane hydrocarbons (TNMHCs) in ambient air. The evaluation of linearity, precision, detection limits (DLs), and stability of retention times (RTs) indicates that the equipment is suitable for measuring ambient air automatically for prolonged periods (6 months). The calibration of the equipment using response factors calculated on the basis of the effective carbon number (ECN) showed variations of over 10% for acetylene, isoprene, and n-hexane. The results provided by the automatic chromatograph correlated significantly with simultaneous results from other widely used techniques for determining VOCs in ambient air: (1) portable GC, equipped with photoionization detector (PID), and (2) active adsorption on Tenax-TA followed by thermal desorption and chromatographic analysis.     

Deposition and leaching of tebuthiuron on sugar cane straw applied with and without alkyl polyglycoside adjuvant

A laboratory experiment was carried out aiming to study the effects of an alkyl polyglycoside adjuvant (APG) on deposition and leaching of the herbicide tebuthiuron applied on sugar cane straw. Tebuthiuron, at concentration of 1200 mg L(-1), was applied separately and in tank mix with the APG adjuvant, at concentrations of 0.07 and 0.09% (wt v(-1)), using a spraying volume of 204 L ha(-1). A precipitation equivalent to 20 mm of rain was simulated, 24 h after the applications, to evaluate the herbicide leaching. The quantification of tebuthiuron was carried out by the high performance liquid chromatography (HPLC). It was observed that the addition of APG adjuvant at 0.07% (wt v(-1)) provided an increase of 11.5% in the deposition of tebuthiuron on straw, reduction of 50.4% in the drift of the herbicide and it did not affect significantly the leached amount (68.5%), when compared with the treatment where tebuthiuron was applied alone (70.8%). At the concentration of 0.09% (wt v(-1)), the APG adjuvant caused an increase of 22.7% in the deposition; it reduced the drift of the herbicide by 99.9% and reduced the leached amount by 7.6% thereby increasing the retention of the herbicide by straw.